We have compiled a list of manufacturers, distributors, product information, reference prices, and rankings for Loop Antenna.
ipros is IPROS GMS ・ IPROS One of the largest technical database sites in Japan that collects information on.

Loop Antenna×ウェーブクレスト - List of Manufacturers, Suppliers, Companies and Products

Loop Antenna Product List

1～2 item / All 2 items

Displayed results
Loop antenna passive 9kHz to 30MHz

Loop antenna passive 9kHz to 30MHz

Designed for radiated emission measurements in the frequency range of 9 kHz to 30 MHz in accordance with CISPR 16.

The loop antenna TBMA6-P is designed for measuring radiated emissions in the frequency range of 9 kHz to 30 MHz in accordance with CISPR 16. The diameter of the loop is 60 cm, providing sufficient sensitivity to perform all relevant measurements specified in the corresponding CISPR standards for the frequency range of 9 kHz to 30 MHz. The loop is constructed from coaxial cable and is attached to the transducer with an N connector. This design allows for flexible use with various loop diameters. An attachment with a ¼-inch screw allows it to be connected to a standard tripod.

  • Time-frequency measurements
  • Other electronic measuring instruments
  • Other measurement, recording and measuring instruments

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
Large loop antenna 9KHz–30MHz

Large loop antenna 9KHz–30MHz

A large loop antenna with three orthogonal loops as required by ISPR16-1-4 and CISPR 15 / EN 55015.

It is used to measure the current induced by the magnetic field emitted from the lighting fixture. Section 4.4 of EN 55015 specifies the test setup and measurement procedures. It consists of three vertical 2-meter diameter loop antennas on three orthogonal planes (X/Y/Z), installed on a lightweight hollow WPC frame with a total height of 2.5 meters. The lowest point of the loops is 0.5 meters above the ground, and each loop element receives magnetic field radiation that is perpendicular to the accommodating plane, generating a voltage signal at the output port of the RF transducer connected to the loop, proportional to the intensity of the H-field radiation. It is equipped with three TekBox TBCCP1-2K70 coaxial RF current monitoring probes with a flat transfer impedance of 0 dBΩ (1V/A) from 9 kHz to 30 MHz at a 50Ω load. The kit includes all necessary coaxial cables, ferrite clamps, a manual RF coaxial switch for selecting loops, and a TBTP3 tripod with a plastic DUT support plate.

  • Other electronic measuring instruments
  • Other measurement, recording and measuring instruments

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
COPYRIGHT © 2001-2025 IPROS CORPORATION ALL RIGHTS RESERVED.